Reguar maintenance is an important aspect of extending the life of your water heater, and problems, like leaking or not heating up, can be managed by repair or replacement. Simple repairs like replacing a heating element or pressure-relief valve can resolve water heater issues and learning some troubleshooting tips can help you in managing your own water heater problems. You can always contact a professional such Camdem Plumbing Consultant to help you with any of your water heater problems, though simple water heater repairs that can be done DIY. The average life expectancy of a water heater is eight to twelve years.
According to a Camden Plumbing Consultant, it is best to replace your water heater if it is already more than 10 years old, with noticeable leaks surrounding the base of the tank, not working, or erratically works. One of the most common problems of water heaters is not getting the expected heat or hotness that might be caused by a defective heating element, or a faulty thermostat. It is essential to make sure that your electric water heater is maintained properly, ensuring that the power is connected, resetting the thermostat as needed, flushing the heater to eliminate sediments from the tank, replacing thermostat and heating element, and raising thermostat temperature. When managing a gas water heater, you need to remove sediment by flushing, replace the Thermo coupler and clean the burner, ensure that the pilot is lit and the gas is connected, insulate hot water pipes, and raise the temperature setting on the thermostat. Buildup of sediments in the tank may cause sizzling or hissing noises, so it is important to drain the tank until the water clears. Removal and soaking of elements in a pan filled with vinegar should be done for up to an hour, and collected scale are scraped off. You have to replace leaking pressure-relieve valve as needed. Replacement of water fittings should be done if tightening them does not work.
It is essential to drain your water heater at least twice a year to remove sediments that cause corrosion and to increase efficiency. A burst of water should be released as you lift the pressure-relief valve handle and snapping it back, otherwise it needs replacement. When replacing your water heater, you need to consider the following features: gallon capacity (40 50 5 liters), recovery rate (number of gallons heated in an hour), dimensions and energy efficiency ratings. Allow us to help you with your plumbing and water heater replacement needs, feel free to check our website or homepage.If You Think You Understand Plumbing, Then Read This